Gap Mountain Drilling, LLC, Ringe, NHCall Toll Free 800-699-9506

Geothermal Energy

Geothermal Benefits

Geothermal Services

Geothermal Drilling


Water Well Drilling & Irrigation


Hydrofracture


Pump Systems & Service

 

Contact Us

Home

 

 

 















































Free Estimate - Visa and MasterCard Accepted

   
Wells, Pumps, Geothermal - Serving NH and MA

 Geothermal Services

Gap Mountain Drilling provides the most efficient and highest quality geothermal heating and cooling systems.

List of Services

  • Consulting and Feasibility Studies

  • Site Visits and Permitting

  • Heat Loss Studies and Equipment Sizing

  • Geothermal Ground Heat Exchanger Design

  • Formation Thermal Conductivity Testing

  • Geothermal Drilling & Loop Installation

  • Site work – Excavation Services

  • Thermally Enhanced Grouting

  • Fusion and Headering Services and Design

  • Pressure Testing – Flow Testing

  • Purging and Charging Services


Header Manifolds for Geothermal System

A geothermal heat pump system consists of a heat pump, an air delivery system (ductwork), and a heat exchanger-a system of pipes buried in the shallow ground near the building. In the winter, the heat pump removes heat from the heat exchanger and pumps it into the indoor air delivery system. In the summer, the process is reversed, and the heat pump moves heat from the indoor air into the heat exchanger. The heat removed from the indoor air during the summer can also be used to provide a free source of hot water.”

geothermal drilling

 

Ground Heat Exchange Systems

Closed-loop Systems
Closed-loop systems generally consist of a buried piping system constructed from high density polyethylene (HDPE) pipe and fittings. This piping system is filled with a water or water-antifreeze solution and is buried in the ground, usually in horizontal trenches or vertical wells. This ground loop acts as the primary heat exchange device for the home. The fluid is circulated through pipes where it either absorbs heat from the ground (heating mode) or rejects heat to the ground (cooling mode) before returning to the GSHP unit.

Open-Loop Systems
Open-loop systems extract water directly out of a water well or pond and run it through the water-refrigerant heat exchanger in the GSHP unit. After the transfer of heat between the extracted water and heat pump takes place, the water is then expelled back into a well, into a pond, or into a drainage ditch depending on local codes.  

There are factors to be considered when selecting the proper ground heat exchange system for your needs, both effective and efficient, and Gap Mountain Drilling will discuss those with you during your consult.

 

Cost Effective – Durable – Low Maintenance

Year Round Comfort – Quiet Operation




              





Gap Mountain Drilling, LLC   |   PO Box 59, Rindge, NH 03461
Located also in Northfield, NH

Phone (603) 899-3107          Toll Free 1-800-699-9506          Fax (603) 585-7771


Geothermal Energy   |  Geothermal Benefits  |  Geothermal Services  |  Geothermal Drilling
 Water Well Drilling & Irrigation  | Hydrofracture  |  Pump Systems & Service  |  Contact Us  |  Home